注意报错提示：
4 c8 _' x5 W7 B* K' A0 x646.04: Load 3 (L_Carton3) is at travel action, but is not on a movement system.1 z x- ?* i! ?' \
646.04: Travel action ignored.* x7 F, U# q+ ?* M) w
646.04: No debugger information is available.* s: |# N3 s& @9 C% r' e3 ^* D% ?8 {
646.04: Load 3 (L_Carton3) is at travel action, but is not on a movement system.
0 ?* v$ }7 u( }! \8 D: J646.04: Travel action ignored." I. V" y; z' u5 m$ n( p- [
646.04: No debugger information is available.3 `9 D$ _% r3 ^5 z
1 K( `- X) d4 t) |9 M7 d回来看代码：
! I/ q3 y0 H! Z n1 V& l
/ ?$ ^# C6 f- G6 q0 u% }begin P_output1 arriving procedure
. k9 Z, x1 K8 @' ?$ x travel to Conv.staoutput1- P6 X1 t9 V! c, X9 a
move into Q_output(1) ; w% H" j$ F- Y3 Q9 H) e
/*Location to wait for a vehicle*/7 r. z: T D+ \/ j! ~9 K
travel to Rgv.cpoutput1 /*Get on Vehicle*/
# J S. N( Q9 ^0 b( e send to P_store; ?) O3 o3 e) h5 |3 {. w9 z
end
- t5 D- S. H) [0 I7 o( D" {
. O* }- g' S2 Dbegin P_store arriving procedure
8 o: u& d9 W J% y* U ~ [ travel to Rgv.cpstore
' k1 r+ M& B' s {9 ~* X6 v /* Travel onboard vehicle to cpstore */
2 {$ P# w9 M Y1 \ move into Q_store /* Get off vehicle */) N4 v% }; ~/ i$ \. ]' e7 g. D/ V& v
wait for 20 sec/ Y- s& f, _) F; A' @+ o5 o& o) i7 @
set A_Time to ac - A_Time5 x3 I3 D) ?8 Y4 j N
print this load, "Time in system " A_Time to message
" ?4 C+ A. L0 ?% a( P4 I% V5 R+ {. Z* J inc V_Numdone by 1$ U2 o, ~3 o0 \2 V; G0 W
send to die: z* t0 ]0 v- C9 U& S9 [; b/ I. j
end
% w3 l2 I9 |" B% ?8 l% [; b
( J8 }, H6 u& U! L+ p( p+ t! x* @知道怎么改了吧？ |
发表于 2009-7-15 21:45:44
