求解

am_simulation

RGV在Q_wait1-6取载后在8个工作站净空、lable
最后在空箱在Q_store流出
0 y1 J8 W8 F" k! ^2 |目前run model结果发现，货物淤塞在staoutput1-8
$ T' `" o  C% }1 \+ o未能流出，求解

zhdew

注意报错提示：
6 E3 N1 R9 ]6 U: W1 b646.04: Load 3 (L_Carton3) is at travel action, but is not on a movement system.
! H: G  u% Q( K) n$ |, S646.04: Travel action ignored.
646.04: No debugger information is available.
646.04: Load 3 (L_Carton3) is at travel action, but is not on a movement system.
646.04: Travel action ignored.
646.04: No debugger information is available.

回来看代码：

begin P_output1 arriving procedure
   travel to Conv.staoutput1
$ r6 F' d' l0 f. N   move into Q_output(1)
   /*Location to wait for a vehicle*/
8 Q; \" E* K# w( a    travel to Rgv.cpoutput1 /*Get on Vehicle*/
   send to P_store
0 J, p* U! T/ P- N  Rend  
  S& Q, z: Q" i- p+ y" x
begin P_store arriving procedure
( m- i, J9 _) C   travel to Rgv.cpstore
   /* Travel onboard vehicle to cpstore */
   move into Q_store /* Get off vehicle */
   wait for 20 sec
   set A_Time to ac - A_Time
   print this load, "Time in system " A_Time to message
   inc V_Numdone by 1
   send to die
; M* l2 F1 a7 @7 {& ]2 }# ^( G% I3 yend
5 T# S# {/ C" N
/ H$ D& I" T7 @- Y5 P% @$ B知道怎么改了吧？