求解

am_simulation

RGV在Q_wait1-6取载后在8个工作站净空、lable
. }( `6 L, l2 ^最后在空箱在Q_store流出
目前run model结果发现，货物淤塞在staoutput1-8
4 Y3 L2 S: Q; A8 L未能流出，求解

zhdew

注意报错提示：
7 x/ a/ c; b5 e4 \1 y646.04: Load 3 (L_Carton3) is at travel action, but is not on a movement system.
646.04: Travel action ignored.
646.04: No debugger information is available.
646.04: Load 3 (L_Carton3) is at travel action, but is not on a movement system.
; d1 F) h" T, c1 `4 q4 \. k" n646.04: Travel action ignored.
646.04: No debugger information is available.

回来看代码：

begin P_output1 arriving procedure
   travel to Conv.staoutput1
& E( R, L/ L; Q0 ~: ^' c' f# y   move into Q_output(1)
   /*Location to wait for a vehicle*/
% x: t, p' U, l( a    travel to Rgv.cpoutput1 /*Get on Vehicle*/
6 h7 R$ J6 O0 Z% l; @! E   send to P_store
end  
" ^( ]' ]2 o0 }0 j3 U2 v  `8 q
7 y& E* S. ?  g3 w% O; t4 G9 d) P# B1 P" Vbegin P_store arriving procedure
   travel to Rgv.cpstore
   /* Travel onboard vehicle to cpstore */
   move into Q_store /* Get off vehicle */
6 d8 p1 A& s% P3 ]2 s   wait for 20 sec
2 F. X. {" j! P9 T1 A7 l) V   set A_Time to ac - A_Time
   print this load, "Time in system " A_Time to message
7 F* y( y5 `3 W, [   inc V_Numdone by 1
   send to die
end

知道怎么改了吧？